Steakmaker
Frequent Contributor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-12-2012
12:55 PM
1650 Oliver Clutch and Hydro
I was driving our 1650 across the yard with the hydro power in low range and it popped into high range on its own. Now neither the clutch or hydro power shifter work. Can anyone tell me what happened?
Thanks
4 Replies
siloguy
Frequent Contributor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-23-2012
10:00 AM
Re: 1650 Oliver Clutch and Hydro
Try this site. It seems to be active.
Jim Meade / Iowa City
Senior Advisor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-23-2012
09:19 PM
Re: 1650 Oliver Clutch and Hydro
That's a new one on me. Yesterday's Tractors is a good site. It sounds like the high side clutch locked up, but I don't know why the engine clutch is locked up.
Steakmaker
Frequent Contributor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-24-2012
07:35 AM
Re: 1650 Oliver Clutch and Hydro
Got it fixed. Evidently there was a bolt that came loose and wedged against a shaft somewhere near the hydraulic pump. Runs like a champion again.
Thanks
siloguy
Frequent Contributor
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-07-2012
07:02 AM
Re: 1650 Oliver Clutch and Hydro
Sometimes it is as simple as that! A rogue loose bolt sounds much cheaper than locked up transmission parts.