cancel
Showing results for 
Search instead for 
Did you mean: 
Aarondeere
Friend

John Deere R450 windrower

Was checking to see if anyone is using this windrower and overall how do they like it and how is it holding up.  I currently have a New Holland HW365 with 15' discbine head with about 850hr and about 8700 acres through it and it is just starting to get unreliable with little break downs often that can cost a day here and there.   That doesn't seem like a big deal but around here with the last couple of springs being very wet it is a big deal.   Feature for feature the JD seems close to what I have.   200hp vs 225 in the NH, both have suspension though my NH also has cab suspension.   The JD does have that active steering system which lets it go 21mph.   That would be a big plus in my book.  The biggest benefit I see is I have a  very strong JD dealer local and they are great for getting parts.  My header has 2 motors on either end that power the cutterbar.  JD has just one that sends power from the one side.  NH says that evens out the power flow.   Is this a big deal?   Also we don't have many rocks so not a big deal but has anyone ever taken out a cutter module on the JD and how hard was it.  They have a shear hub setup on theirs so that should limit any major rip downs.  Thanks

0 Kudos
3 Replies
Frequent Contributor

Re: John Deere R450 windrower

We traded off a Case-IH, which was really a Hesston. It was 15' disk mower with over 4000 hrs. on it and it was very reliable. We traded it on a new Hesston, which seems to be holding up good. Our new one has a merger on it and it doesn't have the 5.9 Cummins like the old one, but it has enough power. At about 3500 hours we changed the rolls on the old one because the old ones were very thin, but a pair of rolls was only $1200 back then. We broke a module stub shaft or two, but they were an easy shop fix. Easy to pull from the machine as well. Other than that, it got a water pump which I put on, and a stub axle on a final drive. I would consider 850 hours to be barely broke in.

0 Kudos
Plowboy1138
Friend

Re: John Deere R450 windrower

I had to replace one on ours today although it was due to the casting wearing out on bottom and leaking the oil out of the head. As for goin 21 down the road yes it will do it but it will take off on you unless the road is perfectly level with no pot holes. Overal it's a decent machine it does a good job operator abuse is a majority to blame for our troubles
0 Kudos
Plowboy1138
Friend

Re: John Deere R450 windrower

The jd had more head speed and torque compared to the nh or hesston we tried out. But we also run an impeller instead of rolls
0 Kudos