Senior Contributor
Posts: 361
Registered: ‎05-14-2010
Accepted Solution

Hub and stub axle source?

I've got a Farmhand feed grinder.  We broke one of the stub axles today right at the inside bearing.  Its a stub shaft abotu 18 inches long and 2-2.5" diameter for a six bolt implement tire.  I'll probably just take it to the Amish repair shop on Monday and have them make me a new one unless someone else has a better suggestion.  I hate to even try to get parts from AGCO because they have no clue about farmhand grinders.  We stold one off the spare grinder to get it going.  It took an awful lot of jacking, blocking, and digging to get it up in the air to work on.  We were lucky it didn't bust in the mudhole.